Re: Wire weed guards


[Bulletin Board]


Posted by Phil Ewanicki on 2019-01-31 12:20:05 in reply to Wire weed guards posted by mikemcc on 2019-01-31 09:21:18

I would suggest 25# hard mono. Take a 6" piece, heat it slightly about 1" from one end, bend it 90 degrees, let it cool. Lay the short end on a hard surface and flatten it somewhat with a hammer. Cut this this short end back to about 1/2 inch from the bend,, lay the flattened end on the hook shank, thread wrap, and whip finish. The long, upright end should be a half inch or so in front of the hook point and trimmed to 1/4" - 1/2" above the hook point. It will be lighter and just as successful and durable as a plastic over wire hook guard.


Follow ups:

  • Re: Wire weed guards With Pictures - Dan Blanton - 2019-01-31 16:57:23 (3 replies) (314 views)
    • Piranha! - Mark A Kuipers - 2019-02-01 17:34:52 (1 replies) (84 views)
      • Re: Piranha! - Dan Blanton - 2019-02-01 18:24:28 (0 replies) (83 views)
    • Re: Wire weed guards - Phil Ewanicki - 2019-01-31 22:16:46 (0 replies) (118 views)


Post a Followup:

Name:
Email:
Subject:

Use the space below to compose your message: