Re: Made in Korea

[Bulletin Board]

Posted by Dan Blanton on 2013-05-22 00:18:43 in reply to Re: Made in Korea posted by JJ on 2013-05-21 20:31:43


Maybe I'm not tracking correctly here, but I don't know of a single disk drag reel of any type where the drag knob doesn't get tighter as you crank up the drank (or crank it down is it were).

It has to get tighter as the drag spring and washers compress.

I own a dozen different reels with disk drags of some sort and they all are the same in this regard.

Now I don't like a disk drag (or any drag) that ramps up too fast - like a half turn of the nob gives you damned near full drag. Eventually though, the drag nob will get very tight if I'm trying to obtain full drag pressure.



Follow ups:

Post a Followup:


Use the space below to compose your message: